views:
Using a ball mill is inseparable from the belt, the tightness of the belt tends to determine the efficiency of the entire device. We are a variety of ways, to make the belt adjustment device prior to use, how to adjust the belt of the device?
1, V-belt rollers of a ball mill should be operated at higher than 60 ℃ environment. Pulley wheel hole cracks, notches or grooves wheel groove faces should have severe wear when timely replacement belt a serious wear and belt contact with the bottom belt aging, crack or plastically distorted condition should have their corresponding replacement, and on the same belt pulley should be replaced at the same time.
2, in order to prevent the belt slipping phenomena, should the belt or belt wax oil applied to the working surface of the belt, but more generally not used, as the belt tension of the belt may increase the occurrence of slippage. Keep the belt and pulley clean to prevent dust intrusion.
3, produced by different plants or different Condition V-belt can not use the same set, different specifications can not replace each other mill belt. Belt should prevent direct contact items acids, alkalis, diesel, oil, gasoline, etc., etc., but also to avoid direct sun exposure it. When the belt is running can not be too tight or too loose, the belt should be adjusted at any time.
we adjust the ball mill belt, pay attention to what may be appropriate to add oil. The other is the time to clean up the belt and the device itself, prevent equipment clogging can not run occurs.
