views:
Using a ball mill can grind a lot of materials, but should also pay attention to prevent overload, because once overload, not only the problem that the equipment does not use, but also affects the entire production efficiency.So we must find ways to prevent its overload:
1, the ball mill does not operate under the rural areas, and prevent the current increase in the current increase in the stator winding. The temperature increase is increased.Overheal burning.
2, rational selection: The actual load condition conditions are matched to the form of the selected ball mill; the choice of the tentative should be appropriate.
3, timely replacement of severe impaired bearings, stator and rotor phase friction \"sweep\" or other debris such as water and water, etc., the mechanical failure of the new ball mill stator windings can cause burnout.
4, improve the quality.
The above is a method of preventing the ball milling. From it can be seen that we must use them in accordance with the requirements when using it. It should be checked in time if it is not used, and it is not possible to put excessive material in one time.
