views:
Many people are very concerned about the output of the rod mill. Generally, the higher the output, the higher its efficiency. So, we also often judge its usage based on its output, and it is also hoped that it can have high yield. So what factors affect the output of the device?
1. Operation time
The length of the production time will affect the components and purity of the product, and the effect of the rod mill time on the particle size is also obvious. At the beginning, over time, the particle size drops lightly, but after a certain amount of time, continue to extend, the particle size value of the product is not too large. The longer the amount of pollution, the longer the pollution caused by the product, affecting the quality of the product.
II. Grinding medium
The grinding medium plays a grinding and impact in a rod mill. Based on grinding, at a certain extent on the abrasive medium, the more the grinding medium added, the amount of the material is ground in the predetermined time, the higher the ball milling efficiency. However, excessive grinding media will occupy an effective space, but causing the decline in yield.
Third, the operating temperature
The temperature increases during operation, and the effective strain of the nanomaterial is reduced, the grain size is increased, affecting the mechanical properties of the powder into a mass material. Regardless of the product being a solid solution, a gold compound, nanocrystals, or amorphous, both involves diffusion problems, and the diffusion is affected by the temperature of the grinding, the temperature is also an important factor affecting yield.
Fourth, high water content
Since material moisture is large, the feed uniformity is affected, and the feed time is extended. Second, since the wet material feeds too much, it may cause the phenomenon of the mating bullet and paste, and \"saturate\" may occur and is forced to stop treatment. In general, each increase of 0.01 in the abrasive material, the output will be reduced by 1%; when the moisture is greater than 0.5, the rod mill is basically improving.
These factors affect the yield of the rod mill varying degrees, so in order to improve the production of the equipment, we can adjust from these factors, and must be strict in material screening. If there is conditional, you can process the material as soon as possible.
