views:
The ball mill is mainly composed of a working portion such as a feed portion, a feed unit, a cylinder portion, and an assembly portion, and a bearing portion, a transmission portion, a speed reducer, a coupling, and the like. The cylinder is welded with a steel sheet, and the bolts are used in both the bolts, and the air is connected in the air, and the horizontally supported in the two main bearings, in the intake, the inside of the empty biliary neck is also contained in the air.
Set and use it as an entry and exit pathway, the inner wall of the cartridge has a high manganese steel liner and a white iron liner, and the cartridge has a certain amount of abrasive medium (ball or rod) and the material to be worn. When the centrifugation is rotated by the horizontal axis, the mass point of the mixture is raised to a certain height due to the action of the centrifugal force, and then the wall is discarded in the tank and the trajectory of the parabola is dropped. Thin, on the one hand, since the impact of the material (ball or rod) falling on the material is broken, on the other hand, the material is crushed between the media and the medium and the inner wall between the cartridges and the material. grinding.
Continuously working ball mill, the abrasive material is continuously given from the ball mill feed end, and the ground product is supplied with the bodder to give the material, hydraulic (wet production) or wind (dry production) and lift plaid Extract exports from the other end of the ball mill.
