views:
ball mill equipment is milled so that the granularity of the abrasive material is greatly reduced, thereby reducing the load of the powder mill; the increase in powder efficiency, the most direct benefit is the finished powder, the fine powder is mostly selected, reducing cement finished products When the feed rate is low, the bearing of the main bearing reaches 65 ° C and continues to rise; the liner, the human hole cover and the rotary portion and other coupling bolts are loose and fractured; the mechanical parts in the mill fall off or ruptured. It is necessary to make a broken powder, and then prepared as a suspension as required. Generally, the density δ of weight is required to require the physical density ρ of the suspension, as long as the solid-liquid mass ratio M is calculated according to the formula: m water (M quality is the mass of weight, the mass of m water) The resulting suspension mass fraction is smaller, and contains more contaminants, according to the properties of the weight, can be purified by magnetic separation, flotation or reselection method, and then use a hydraulic cyclone, tilting plate. The equipment such as a concentrate is dehydrated, and the return process is used again. This proportion can then be set to any volume of suspension. The lubrication system has a breaking oil failure. When the operation of the reducer and the operation of the motor occurs.
More than the weight of the weight is required to have a certain fineness. When the weight is a block, if the factory conditions permit, the above three methods are used, the effect is most ideal, which is also in recent years. Great trend in the design of the grinding system. The relationship of the three: precipitation is premise that the grinding powder is guaranteed, and the retrieval of the grinding is fundamentally. The large ball mill equipment is not allowed to have significant tilt and sink, if there is a small set, it should be equalized and horizontal, otherwise it cannot be installed. The basis of the large ball mill should have sufficient height to supply the replacement liner and the grinding medium. The basic design can be made to the baseline of the large ball mill, reducing the load of the mill; and the grinding is modified, that is, the improvement of the powder milling system. If the mill suddenly power off during the operation, it should immediately put the mill and its The motor power switch of the attached device is cut off, and the ball mill must be installed on the basis of dry solid reinforced concrete.
