views:
ball mills buy home, although there is an instruction manual, but before watching, let's take a look at the order of the operations to summarize you.
(1) Preparation before the ball mill starts:
1. Check if someone in the dangerous place.
2, check if the lubricant of each lubrication point is appropriate, and it is added when it is insufficient.
3. Check if the steel ball filling rate in the ball mill meets the requirements.
4, check the abrasive liner bolt, the bolt is loose and reliably tightened with the bolt and the barrel connection bolt.
5, the inlet cover is reliably fixed.
6. Check the phenomenon of the barrel bolt hole and the in-hole, etc., and eliminate it.
7. When the first trial operation or long-term stop is started again, first, the hollow bearing is first poured on both ends, and use artificial mill mills, or \"point\" rotation once, confirm that there is no abnormal phenomenon.
8, and contact the job position before and after obtaining the signal to be started after the starter can be started.
(2) The order in which ball mill starts:
1, the starting powder output device.
2, start the ball mill.
3, start the feeder.
(3) The order in which the ball mill is stopped:
1, stop the feeder.
2, stop the ball mill. Long-term parking should take the steel ball and material blood.
3, the conveyor continues to run until the machine is discharged, and then stops.
