views:
The ball mill has played a considerable role in grinding various materials, however, since some doors did not pay attention to position, leading to the occurrence of partial failures, causing equipment damage, in fact, these can be avoided. For the user, the device is driving, you need to pay attention to these points:
1. After checking, press the start button to start the motor, pay attention to the current change. The ball mill continuous start must not exceed two times, once and more than 5 minutes, if the start is started three times, it must be started after the electrician, the fitter, and the fitter can be started. Do not start with other devices, to interlate start to avoid tripping.
2, after normal operation, add primary water and pulverization as required, prohibit overload operation, and idling time does not exceed 15 minutes to avoid damage to the line.
3
4, the operation should be taken to observe the hollow shaft, the oil ring is turned oil, whether the hollow shaft temperature is normal, if the hollow shaft is hot, it should be taken immediately, and it should be taken immediately, and should not be stopped immediately. \"Mount\". At the same time, pay attention to check the oil volume, temperature, and timing of each lubrication site.
When the ball mill is driving, you can't just know how to do it. There are a lot of precautions that we should notice that we should check at any time during operation, only this will make the equipment longer.
