views:
We want to be familiar with the rod mill, then we should be familiar with all parts of the equipment. After familiarity, we can know some of its functions, steel bases as part of the equipment, maybe some users don't pay too much attention to this place, the following is a steel base Detailed:
1, the sliding bearing four steel bases are mounted on the V shape, and the steel base is generally a cast iron member, and the lower surface should be finished.
2, the first tail of the rod mill, the vertical side of the steel base, the horizontal center line allows the deviation ≤ ± 0.5mm; the first tail two sets of steel base diagonal allowed deviations ≤ 1.5mm.
3, the center of the first end of the two sets of steel bases is allowed to deviate ≤ soil 3mm; the horizontal level of the two sets of steel base allows deviations ≤ 0.05 mm / m.
4, the upper surface of the two sets of steel bases on the first tail of the rod mill allows the deviation to be ≤0.5mm, and the discharge end is not higher than the feed end.
5, after the two sets of steel bases are rough, the grout can be performed.
The steel base of the rod mill can be supported, and it is an indispensable part throughout the device. When we check the equipment, we can check if you meet the requirements in accordance with the requirements listed above.
