views:
The components in the rod mill are actually have a certain life. After using a period of time, we should replace the components in time so that the equipment continues to use, and the manufacturer gives the manufacturer to the following recommendations:
1, all lubricants should be released in a rod mill to put continuous operation 1 month, clean and replace new oil.
2, each lubrication point lubrication condition and the height of the oil surface check once at least half a day.
3, when running, the temperature rise of the main bearing lubricant does not exceed 50 degrees. The temperature rise of the transmission bearing and the reducer does not exceed 50 degrees, no more than fifty-nine degrees.
4, if the rod mill is not normal, it should be immediately stopped, in order to find the defect elimination hidden danger, in addition to everyday maintenance, it is also necessary to regularly stop, and important components such as the hollow axis, main bearing, Cylindrical, reducer, size gear, etc. are carefully checked, which is recorded in detail.
5. Replace should be replaced by 65 percent or with a seventy-two mm long crack.
6. When the spiral wear of the inlet and discharge should be welded, and the components should be replaced when wear until it cannot be welded.
For the rod mill replacement parts, the manufacturer gives some suggestions. When replacing the part, you need to do a good lubrication operation. For the entire device, its lubrication is important. We must notice when replacing parts.
