views:
When we start using a ball mill, we will set the device, and its installation process needs to be familiar with it. After installing it, you can start some operations. If you are not installed, how to do it is also futile. So I hope everyone can be familiar with its installation, bring benefits to future efficient use. The following is its installation step introduction:
1, mounting ball mill base
can prepare some thickness of hinges for standby. When installing the base, the main role of the horn is to adjust its position and should ensure the amount of horn. Normally, the bottom side knock does not make loose, that is, it is considered qualified.
Before installing the base, be sure to analyze the base in detail, and there is no relevant design requirements. Observing the main bearing on the center line, its coincidence is not more than 0.5mm, and the feed end should usually be approximately 1 mm above the feed end. Further, after the high bolt is fastened, the chassis detection can be performed with the aidometer to see if it is on the same horizontal line.
2, the process of mounting the ball mill main bearing
should ensure that the journal of the ball mill and the bearing can operate, and have better contact performance. During the installation, it is also necessary to ensure that the two hollow shafts have the same axis, and should control the central axis and between 0.5 mm distance gap between 0.5mm and 1 mm, and there is a certain scalability on both sides of the free end. Especially in areas where some seasonal temperature differences, the hollow shaft shoulders and the shaft space are prone to have some differences. If it is not set, the bearing temperature is high, and there will be adverse cases such as bearings.
The ball mill is mainly to crush various materials, and the fine powder is made by grinding. Many times, because the installation does not follow the steps, some damage occurs, so in order to enable the equipment for a long time, please Everyone must use the steps in accordance with the steps. Be sure to check it several times after installation, don't wait until you use it.
