views:
The rod mill can further grind the material that has been broken, obtaining a finer material, which also uses the relevant process when used, so that the material is grinded with appropriate help. Let's introduce it to its rod adding process:
1, see the fineness: If the rod mill is equipped with reasonable reasonably, it will come out reasonable fineness, when the discharge is too small, properly add a thick rod, Adding a fine stick is appropriately added; the steel rod is different from the steel rod wear velocity of different diameters during the grinding process, which is caused by the difference in technical standards in different diameters; there is a reason that some steel rods appear. The bending stick disrupted the normal operation of the steel rod, resulting in not grinding. In the case of the above situation, the steel rod should be sorted, and the thread is extracted, and the qualified large diameter steel rod is added to run again.
2, see production: If the amount of processing is unchanged, if the output is dropped, it has to consider whether the steel rod inside the rod mill is sufficient, although the steel rod is added on time, but because of the timely stroke, fine The rod can no longer play the role of \"rod\" in the rustic mill, which is equivalent to \"stubborn\", when it is fine enough, either becomes a twist sample, or broken into one section, there is production Great influence.
3, listening to the sound: The normal steel rod is relatively stuffy in the mill, if there is a broken or bent, listen carefully, he will hear more crisp impact, not the stubborn caused the stick At this time, it is timely stop inspection to avoid greater losses.
The rod of the rod mill is often related to its discharge fineness, yield, and the sound sent by the equipment. When we use the equipment to graze the material, we should also combine suitable processes and improve efficiency.
