views:
When running the rod mill normally, as long as there is no fault, it is not necessary to stop it as soon as it is normal. However, if the device has the following cases, no matter what reason, be sure to stop in time, and do a good job. Preventing an abnormal device:
1, such as a lubrication system, the power supply system fault, or the device itself has failed, and when these faults cannot be processed under operation, it is necessary to stop repair.
2, the rod mill bearings, motor, and slow speed, the temperature is higher than 80 ° C;
3, the power supply system appliance is faulty can not charge;
4, the rod mill and the like have a spark , Smoke or abnormal sound, and last longer;
5, the system is not normal, suddenly break oil, but the bearing is not overheated; the oil volume is small and the reason is not.
When using the above cases, this time must stop in time, do not continue to run it. Be sure to repair it after stopping, in accordance with the correct method during the maintenance.
